Skip to Content
Home └Mindray DC-60 Diagnostic Ultrasound System └Quiz

Mindray DC-60 Diagnostic Ultrasound System

0 %

Completed

Course content

Quiz

10 XP
Prev Next
Fullscreen Share

0 0

There are no comments for now.

Join this Course
to be the first to leave a comment.

1. 1. Before disassembling any part of the DC-60 for servicing, what is the MOST important first step?
a) Put on anti-static gloves b) Clean the area around the system c) Disconnect the AC power cord from the wall outlet d) Document the serial number
2. 2. Which unit is primarily responsible for managing the ultrasound transducers and beamforming?
a) The Back-end Unit (PC Module) b) The Power Supply Unit c) The Front-end Unit (Engine Board) d) The User Interaction Unit
3. 3. What is the primary function of the PHV Module?
a) To power the computer motherboard b) To provide programmable high voltage for the transmission circuit c) To charge the internal battery d) To control the monitor's brightness
4. 4. If the system's AC power indicator is on, but pressing the power button does nothing (no lights, no fan), which component is MOST likely faulty?
a) The Hard Disk Drive (HDD) b) The PC Carrier Board c) The Monitor d) A transducer
5. 5. Where should you go in the software to add a new network printer?
a) [F10] Setup -> DICOM Preset b) [F10] Setup -> Print Preset -> Add Printer c) [F10] Setup -> System Preset -> Key Config d) The Windows Control Panel
6. 6. How should you clean the lens of a transvaginal (intra-cavity) probe?
a) Submerge it in disinfectant liquid for 30 minutes b) Use an abrasive scrub pad to remove gel c) Wipe it gently with a soft cloth dampened with a mild soap solution d) Use compressed air to blow off the debris
7. 7. What is the key combination to access the Service login menu?
a) Ctrl + Alt + Del b) Ctrl + / c) F10 + Esc d) Power button + Freeze button
8. 8. The built-in Maintenance Self-Test tool is primarily used for:
a) Measuring fetal heart rate b) Diagnosing hardware problems with specific boards and components c) Optimizing image quality for abdominal scans d) Updating the system software
9. 9. Why is it critical to regularly clean the dust-proof meshes on the system?
a) To improve the image resolution b) To prevent the system from overheating due to poor airflow c) To make the system look newer d) To avoid error messages on the screen
10. 10. If a customer reports that a newly connected printer does not work, what should you check FIRST?
a) Replace the PC Module b) Run the ECG self-test c) Verify the printer is powered on and the USB cable is securely connected at both ends d) Reinstall the entire system software